Install hho

You might have to remove some parts like plastic covers, over the engine, front bumper, or plastic inner fender above some wheel to be able to check it out.

There could be some space. Then you can think of mounting it in the trunk, as a second option. You need all wires to be as much short as possible.

It can be much easier for you when you have to do the wiring then. But there will be extremely long wires from the front to the backside of the car. I do not recommend in terms of the possible breaking of the cables, which must be secured!

In case of any gas leakage, there is no ventilation. The gas will be kept in the vault, which is not safe. Before you proceed with the installation, have a look in the engine bay, the best place to mount the HHO kit. You can try between the cooling radiator and bumper.

Make sure the Dry cell will be attached in a proper position and also well connected with bolts to the chassis. Besides, you must be able to plug the hoses into the Push-In fittings after the installation. The only requirement is that the HHO tank must be installed on a higher level than the HHO Dry cell because the electrolyte must go into the Dry cell only by the gravity way.

The only condition about the bubbler is that there is a small pipe comes out from the bottom of the HHO bubbler. This little pipe determines the maximum level of liquid inside, which is condensation water.

Just this small pipe sometimes is dripping off it to release the extra condensation water, the same as from the air-conditioner of the vehicle. Just be careful where you will install this HHO bubbler. A compact device so that you can find space for it.

It must be in a dry and cool place in the engine bay. The most important must accessible from you because, after installation of all items and connection of all wires, you will have to set up the Dynamic PWM.

With the two hidden buttons on the Dynamic PWM, you can set it up via the manual for programming. After finish with the installation in the vehicle of all hoses, wires you can prepare and fill it with electrolyte.

The electrolyte is the raw material to produce HHO gas. Advice: If you are handy and you have all need tools, you can do it yourself in less than two hours! That is all when we are talking about light vehicles. The purpose of these videos is not to prove whether or not "on demand hydrogen" technology works, that has long been settled, with more and more proof continuing to back it up every month. Rather, these are to try to help people understand HOW to install the hho kits properly, so they can have a good example, and bolster the industry to continue making headway into this new technology.

Designed by Out of the Sandbox. Powered by Shopify. Note and Disclaimer: Hydrogen or Hydroxy gas and hydrogen cells are experimental technologies, results vary depending on application success is not guaranteed.